1 karl  1.1.2.2 // Copyright (c) 2005 DMTF.  All rights reserved.
 2               // <change cr="ArchCR00066.004" type="add">Add UmlPackagePath
 3               // qualifier values to CIM Schema.</change>
 4               // ==================================================================
 5               //  CIM_BGPIPRoute 
 6               // ==================================================================
 7                  [Version ( "2.6.0" ), 
 8                   UMLPackagePath ( "CIM::Network::BGP" ), 
 9                   Description ( 
10                      "BGPIPRoute describes a BGP routing entry that connects two "
11                      "peer routers that are running BGP. The source and destination "
12                      "addresses may be either specific IP endpoints or IP subnets. "
13                      "Examining the BGPIPRoute class definition, note that its "
14                      "superclass IPRoute is deprecated. Unfortunately, IPRoute "
15                      "cannot be removed from the object hierarchy without a major "
16                      "Schema release. When/if this occurs, the IPRoute superclass "
17                      "will be removed, and BGPIPRoute will subclass from "
18                      "CIM_NextHopRouting directly." )]
19               class CIM_BGPIPRoute : CIM_IPRoute {
20               
21                     [Description ( 
22 karl  1.1.2.2           "Usually, the administrative distance is used to "
23                         "determine which route gets installed in the routing "
24                         "table. Using this scheme, routes learned via EBGP will "
25                         "win over routes learned via an IGP. If this is not "
26                         "desired, then this assigns the administrative distance "
27                         "of this route to be equal to that of a local route, "
28                         "which means that the same route learned by an IGP will "
29                         "have a lower administrative distance and be installed "
30                         "instead." )]
31                  boolean IsBackDoorRoute;
32               
33                     [Description ( 
34                         "Loopback interfaces are often used by IBGP peers, "
35                         "because they eliminate a dependency that would otherwise "
36                         "occur if the actual IP address of a physical interface "
37                         "was used to configure BGP. The loopback interface "
38                         "instead instructs the router to use any available "
39                         "interface." )]
40                  boolean UsesLoopbackPeering;
41               
42               
43 karl  1.1.2.2 };