Return to CIM_ADSLModem.mof CVS log

Up to [Pegasus] / pegasus / Schemas / CIM2101 / DMTF / Device

BUG#: 4412

TITLE: Install and connect CIM 2.10 schema

DESCRIPTION: Adding DMTF CIM schema version 2.10.1

// Copyright (c) 2005 DMTF.  All rights reserved.
// <change cr="CIMCoreCR00752.000" type ="change">Update of
// descriptions based on Tech Edit review.</
// ==================================================================
//  CIM_ADSLModem
// ==================================================================
   [Version ( "2.10.0" ), Description (
       "The ADSLModem class represents Modems of the DSL type = ADSL, "
       "Asymmetric Digital Subscriber Line.")]
class CIM_ADSLModem : CIM_DSLModem {

      [Description (
          "Noise Margin of this Modem with respect to its received "
          "signal, in tenths of dB."), 
       Units ( "Tenths of Decibels" )]
   uint32 NoiseMargin;

      [Description (
          "Measured difference in the total power transmitted by the "
          "peer Modem and the total power received by this Modem. This "
          "value is measured in tenths of dB."), 
       Units ( "Tenths of Decibels" ), Gauge]
   uint32 LineAttenuation;

      [Description (
          "Status indicates the current state of the connection "
          "(line). The property holds a bit map that describes the "
          "possible conditions. For example, \n"
          "1) No Defect - There are no defects on the line; \n"
          "2) Loss Of Framing - ATUR failure due to the inability to "
          "receive a valid frame; \n"
          "4) Loss Of Signal - ATUR failure due to the inability to "
          "receive a signal; \n"
          "8) Loss Of Power - ATUR failure due to loss of power; \n"
          "32) Loss Of Signal Quality - Loss of Signal Quality is "
          "declared when the NoiseMargin falls below the minimum "
          "NoiseMargin, or the bit-error-rate exceeds 10^-7."), 
       ValueMap { "1", "2", "4", "8", "32" }, 
       Values { "No Defect", "Loss Of Framing", "Loss Of Signal",
          "Loss Of Power", "Loss Of Signal Quality" }]
   uint32 LineState;

      [Description (
          "Measured total output power (in tenths of dB) transmitted "
          "by this Modem."), 
       Units ( "Tenths of Decibels" ), Gauge]
   uint32 TotalOutputPower;

      [Description (
          "Indicates the maximum currently attainable data rate for "
          "the Modem. This value will be equal to or greater than the "
          "current line rate."), 
       Units ( "Bits per Second" )]
   uint32 MaxDataRate;
};